Version 6.48.0.0 of Flex out now
New protocol for Bosch MG1CP007 OBD unlock.
Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit.
You will be able to rapidly and safely optimize performances of Porsche vehicles.
Moreover, in addition to map writing, this protocol also includes the “Write Maps and Code” function to a comprehensive programming of ASW + Maps.
This new solution is suitable for all the above-mentioned ECUs, no matter the year of production: engine control units produced after July 2020 (currently not supported in Bench) will therefore be covered, too, for OBD programming.
Please note: if the virtual read is not available, the unlock procedure is not applicable.
Some of the supported vehicles:
- Porsche 911 (992) 3.0L GTS 480PS
- Porsche 911 (992) 3.8L Turbo S 650PS
- Porsche 718 Boxster (982) 4.0L GTS 400PS
- Porsche 718 Cayman (982C) 4.0L GTS 400PS
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- Porsche Bosch MG1CP007 TC299 Virtual Read/Write/Checksum Calculation Maps, Virtual Read/Write/Checksum Calculation Maps & Code
Writing Time: ~ 2 minutes
Bug Fix:
- Added new CRC type for Mercedes Continental MCM/ACM
- Added new CRC type for Porsche Continental Simos19.3
- Added new CRC type for PSA Siemens SID801A
- Added new CRC type for Force India Delphi DCM7.1AP
- Added new CRC type for BMW Continental MSD85 Fxx
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC type for Tata Delphi DCM3.7AP
- Added new CRC type for Tata Bosch EDC17C69
- Fix CRC type for Kia Kefico CPEGD2.20.1
Software Improvements
- Added support for Porsche in Continental Simos19.3
- Improved authentication on MG1CS011