OBD solutions for Renault and Nissan

Version 6.37.0.0 of Flex out now

A new protocol adds up to Flex‘s vehicle list: from today on, you can work on Hitachi BED 434 ECUs in OBD mode.

Elaborate engine parameters of vehicles from Renault or Nissan by accessing the map zone directly from the diagnostic port of the vehicle.

With this new solution, you will no longer need to remove the engine unit from the vehicle, therefore being able to easily and rapidly program in OBD.

Some of the supported vehicles

• Nissan Juke 1.6L Nismo 185PS
• Nissan Qashqai 1.6L DIG-T 165PS
• Renault Clio RS 1.6L TCe 200PS
• Renault Kadjar 1.6L TCe 165PS
• Renault Megane IV 1.8L TCe 225PS
• Renault Talisman 1.6L TCe 200PS

This new protocol is available for the following software packages
OBD

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave

Newly added protocols
(OBD)

• Renault / Nissan Hitachi BED434 Read/Write/Checksum Calculation Maps

Reading Time ~ 2 minutes and 30 seconds Writing Time: ~ 1 minute and 30 seconds

Bug fixes

• Added new CRC type for Abarth Bosch ME17.3.0
• Added new CRC type for Volvo Bosch EDC7C1
• Added new CRC type for FCA Marelli MM10JA
• Added new CRC types for Mazda Melco E6T

Software improvements

• Added OBD Full and Bench Support for Mazda SHxx SH72546

Click here to discover the full list of supported vehicles.