Italiano 
Français 
Deutsch 
Español 
polski 
简体中文 
Version 6.52.0.0 of Flex out now
Download the new software update of Flex and work on Mercedes vehicles equipped with Delphi CPC2 with TC1793 and TC1797 processors.
Connect in Bootloader Powertrain control units and get access to the full content of Internal Flash and Internal EEPROM memories: you will be able to optimize torque and speed limiter parameters or to edit fluid flow inside the intercooler, in order to adjust the temperature of aspirated air.
We remind you that Flex V1 will soon be disabled.
Download the Flex V2 setup here and install the new interface in a few simple steps*
*If your subscription is currently inactive, you can still use Flex V2. However, the Datalogger feature and protocols released after the expiration date of your subscription will not be available.
Some of the supported vehicles:
- Mercedes Class A W176 200d 2.1L 170PS
- Mercede Class B W246 180d 1.8L 109PS
- Mercedes Class C W205 220d 2.1L 170PS
- Mercedes Class CLA C117 200d 2.1L 136PS
- Mercedes Class GLC X253 250 Blue Tec 2.0L 210PS
- Mercedes Class ML W166 400 Blue Efficienty 2.0L 334PS
- Mercedes Class S W222 350 Blue Tec 3.0L 259PS
This new protocol is available for the following software packages:
Boot
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
- FLS0.5S – Flex Full SW Package;
- FLS0.5M – Flex Full SW Package.
Newly added protocol:
(Boot)
- Mercedes Delphi CPC2.x TC1793 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Read/Write Full Backup
- Mercedes Delphi CPC2.x TC1797 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Read/Write Full Backup
Reading Time: ~ 1 minute Writing Time: ~ 1 minute
