Online training on BMW Immobiliser Systems

A two-hour professional training dedicated to Immobiliser Systems of BMW vehicles.

This online course includes an introduction to EWS Immobiliser (Elektronische Wegfahrsperre), first BMW immo system introduced in 1993, as well as the explanation of the evolution of this category of immobilisers up to current FEM/BDC systems. Main topics will therefore be key programming, practical cloning procedures, replacement, alignment or control unit reset.

You will be shown CAS (Car Access System) systems, from the first version (CAS1) to the encrypted, fourth version (CAS4+), with a focus on recent models implementing the new FEM/BDC systems.

Get your spot to learn procedures, practices and case studies to perfectly manage key programming of BMW vehicles.

See you on June 27th from 7.00 pm to 9.00 pm.

*Please note: the course will be held in Italian only.

Program Summary

• OBD and Bench programming, when and how to choose the right programming channel for keys
• Reading modes for the BMW immobiliser code (ISN)
• File reset when the main file of the immo module is corrupt
• Module cloning and replacement (ECU, TCU, CAS, FEM, BDC)
• Key generation via OBD / Radio command reset / Key unlock
• Disable / Enable key from EEPROM
• System programming analysis of CAS1, CAS2, CAS3, CAS3+, CAS4, CAS4+
• DME and EGS code writing in the CAS system
• Solving failed ignition problems caused by the steering wheel lock
• CAS-DME synchronization
• CAS-ELV synchronization (for steering wheel unlock and failed ignition resolution on CAS1, CAS2, CAS3, CAS3+)

FEM/BDC systems (Front Electronic Module / Body Demain Controller)

• Programming in all key lost conditions
• File recovery when the main file of the immo module is corrupt
• FEM/BDC module replacement operations
• System unlock procedure
• Enable/Disable Lost/found keys
• Steering wheel lock system reset
• ISN reading from the original key
• Reseller key preparation
• Backup and coding reset
• DTC cancellation