Software Flex TCU

Flex v2.1.0.0 released

Dear customers, Considering priorities and your own interests, we decided to delay a little bit BDM protocol release to provide you something more important and recent. For this reason version 2.1.0.0 will include new bench and boot tricore protocols as well as TCU bench protocols (known on X17 as clone/restore protocols)! For your comfort, we
Etiquetado bajo: ,

Flex v2.00.00 released

Please note you will need last version of one of the following browsers to run Flex: Google Chrome (recommended) Mozilla Firefox Microsoft Edge The following browser will have incompatibility with our software and should never be used to work on a control unit: Internet Explorer (any version) Once installed, just launch Flex.exe, then connect Flex
Etiquetado bajo:
Full-Bench-MEDC17-Software-

FLEX: released Bench BOSCH MEDC17

FLEX: released Bench BOSCH MEDC17… we’re off to a great start!   To work on most BOSCH MEDC17 engine control units in Bootloader mode, it is necessary to open the ECU, connect to the PCB, then reseal and close the unit again. All this is very time consuming but now FLEX offers you the perfect
MAGPro2 X17 ver 12.08.00 released

MAGPro2 X17 ver 12.08.00 released

Standard release for MG1/MD1 BMW + some new protocols and several bug fixes, while we go towards release of Flex. New Protocols Added: Audi Continental SIMOS 18.2 Bootloader Maps Read/Write/Checksum, Bootloader EEPROM Read/Write, Backup/Restore Full Read/Full Write BMW Fxx Bosch Hybrid (Electric Motor) Control Unit HCU TC1797: Bootloader EEPROM Read/Write/Checksum/Recovery BMW Gxx Bosch MD1CP002 OBD
Etiquetado bajo:

MAGPro2 X17 ver 12.07.00 released

Welcome to our summer release! MAGPro2 X17 ver 12.07.00 released We have a lot of hot new protocols which you have been waiting for years. First in the list are the newest bosch engine control unit type, MG1 and MD1. From today it is finally possible to access them in OBD mode for the models
Etiquetado bajo:

MAGPro2 X17 ver 12.06.00 released

We are releasing ver 12.06.00 of MAGPro2 X17: this update, aside several software improvements, focuses on two important brands, for which we added exclusive new protocols: 1. Volvo, for which we added support both for tractors (with Kubota engine) and, most importantly, all 2.0 engines from 2014 to 2017 using Denso ECUs with processor SH72546R!
Etiquetado bajo: