Flex for Master Users: Training in Erchie

Attend the advanced training course about Flex, the professional engine control unit (ECU) and transmission control unit (TCU) programmer dedicated to Master users.

Reserve your spot to learn new skills on protocols and read/write methods, on ECU/TCU modification and cloning, as well as on control unit recovery and restore. Moreover, the difference between a Master account and a Flex account will be explained further.

PLEASE NOTE: this course will be held in Italian only.

Requirements:

• Basic knowledge of electronics applied to engines
• Familiarity with ECU/TCU communication protocols
• Past use of diagnostic tools

ADVANCED INTRODUCTION TO FLEX

• Differences between Flex Master and Flex Slave
• Helpdesk: structure and services
• Flex software: installation and setup
• License activation and management

COMMUNICATION PROTOCOLS AND READ/WRITE MODES

Introduction to protocols such as:

• OBD (On-Board Diagnostics)
• Bench Mode
• Boot Mode
• JTAG & BDM
• Choice of the correct mode for ECUs and TCUs
• Practical examples on several types of control units

ECU/TCU MODIFICATION AND CLONING

• ECU read and full backup
• Binary file editing via dedicated software (AI Solution)
• Cloning the original control unit on a spare unit
• Verification and safe writing of mod files

SOLUTIONS TO COMMON PROBLEMS AND RESTORE

• Locked ECU recovery
• Control unit restore in Boot Mode
• Final test with practical session on real cases

Q&A AND CASE STUDIES

• Questions and answers with the trainer
• Case studies and common problems

OBJECTIVES OF THE COURSE

• Use Flex Master correctly on ECUs and TCUs
• Carry out advanced modifications and safe cloning
• Solve technical problems autonomously