Flex version 6.46.0.0 out now Program with Flex the last generation ZF 9-speed transmission unit. New exclusive solution released, completely free of charge, allowing you not only to read and write the map area but also to access the EEPROM memory. You can now optimize shift times or remove DTCs from the 9HP50 TCU installed

Flex version 6.45.0.0 is out now A new protocol to program ZF 8G Tronic VGS3-FDCT automatic transmissions (TCUs) installed on Mercedes vehicles has been released. With this latest Flex update, it is now possible to connect the gearbox control unit in Bench mode and access both the maps area and the EEPROM memory for TCU

OBD Solutions for Nissan and Infiniti Program in OBD mode the engine control units BED310. A new update has been released to optimize the engine parameters of Nissan and Infiniti branded vehicles: access the maps area directly from the vehicle’s diagnostic port without having to remove the ECU. NOTE: For Keyless vehicles, it is necessary

Version 6.43.0.0 of Flex out now New protocol of Flex released to program Bosch MG1CS036 ECUs in Bench. From now on, you will be able to access Internal Flash and Internal EEPROM memories in Bench mode, to optimize engine maps or remove DTCs from Ford vehicles. This new solution allows you to work directly from

Version 6.42.0.0 of Flex out now Program in OBD and OBD on Bench Marelli 9DF ECUs with hardware version HW002. The new Flex update (vers. 6.42.0.0) is out now, allowing you to read Internal Flash and External EEPROM memories, download the virtual read of our database and write the full content of the Internal Flash

Version 6.41.0.0 of Flex out now OBD protocol to program Hitachi BED 501 ECUs is out: a new update of Flex has been released, allowing to optimize engine parameters of Renault and Alpine vehicles by accessing the map area directly via the diagnostic port of the vehicle. With this new solution, you can have a real read at the map area and program